Features a 
 Sealant, silicone sealant, sealant electronics, electronic fixed plastic, silicone, silicone, and its salient features are: has excellent temperature resistance (-60-280 degrees), good adhesion, moisture, earthquake, corona-resistant, anti-leakage and anti-aging properties, are widely used in situations that require high temperature bonding and sealing. : 
 Second, one-component room temperature curing silicone performance test data and the specific uses that 
 Model X-507 
 Appearance of the red and white flowing gray 
 Dry time (min) 10-60 
 Tensile Strength (mpa) 10 
 Temperature (℃) -60 ~ 280 
 Elongation (%) ≥ 200 
 Shear strength (mpa) 9.2 
 Peel Strength KN / m ≥ 1.0 
 Shore hardness (A) ≥ 30 
 Surface resistivity (Ω) 3 × 1014 
 Volume resistivity (Ω / cm) 5 × 1013 
 Dielectric constant (LMHz) ≤ 3.2 
 Power value dielectric loss angle is (10/HZ) 4 × 10-3 
 Dielectric Strength (KV / mm) 17 
 Note use of films dedicated to ptc, plug the sensor surface coating line and film, fixed, bonding, sealing. Not inferior to imported products 
 Third, the use of technology: 
 1, clean the surface: The surface is sticky or coated finishing clean, remove rust, dust and oil and so on. 
 2, the sizing: cut open with a blade tip of the front part, put beak, glue gun with a squeeze pushed to the surface has been cleaned, so that distribution will be a fixed closed surface can be glued. 
 3, the cure: to be glued or sealed parts in the air, let the natural cure. Curing process is a cure from the surface to the internal process within 24 hours (wet and 50% relative humidity, temperature) glue curing depth of 2 ~ 4mm, if the position deeper, especially in the air is not easily accessible to the site , completely cured of the time will be extended, if the temperature is low, the curing time will be extended. In for further processing or packaging components to be bonded, it is recommended users wait long enough to make the bonding integrity of the firm and not be affected.