I. Features: 
 Sealant, silicone sealant, sealant electronics, electronic fixed plastic, silicone, silicone, single component moisture curing temperature of silicone. Rubber elastomer after curing, has excellent resistance to alternating hot and cold properties, aging resistance and insulation properties, excellent moisture-proof layer, seismic, corona resistant, anti-leakage performance. Silicone sealant in general, compared with excellent adhesion to the substrate, resistance to yellowing and moisture resistant. 
 Second, one-component room temperature curing silicone performance test data and the specific uses that 
 Model X-502 
 Appearance is not flowing white 
 Dry time (min) 5-25 
 Tensile Strength (mpa) 30 
 Temperature (℃) -60 ~ 220 
 Elongation (%) ≥ 50 
 Shear strength (mpa) 15 
 Peel Strength KN / m ≥ 2 
 Shore hardness (A) ≥ 50 
 Surface resistivity (Ω) 2 × 1013 
 Volume resistivity (Ω / cm) 2 × 1016 
 Dielectric constant (LMHz) ≤ 4 
 Power value dielectric loss angle is (10/HZ) 2 × 10-3 
 Dielectric Strength (KV / mm) 12 
 Note dedicated to a variety of uses radio, cold light, energy saving lamp, lamp base of the stationary seal pin 
 Third, the use of technology: 
 1, clean the surface: The surface is sticky or coated finishing clean, remove rust, dust and oil and so on. 
 2, the sizing: unscrew the hose blocks and the first punctured with a cap seal cutting-edge, clean the glue has been pushed to the surface of the adhesive seal. 
 3, the cure: the good parts in the air in the coating and curing process is a cure from the surface to the internal process within 24 hours (wet and 55% relative humidity, temperature) glue curing depth of 2 ~ 4mm, and if deeper parts of the location, especially in the air is not easily accessible to the site, completely curing time will be extended, if the temperature is low, the curing time will be extended.